Portal Gun

3D Printed Cosplay Prop Portal Game Portal Gun

**NEW VERSION 9/3/2025** 
The Portal Gun has gone through a slight upgrade! The gun will now have brackets on the underside to be able to fit a shoulder strap to the gun. This helps on those long cosplay days where a nice place to put the gun down isn't always available and you need both hands, or to hold the gun on your back! The max width of the strap is 1.5" or 38mm. The supplied strap has a maximum length of 56" and is adjustable.

This is a full sized Portal Gun from the game Portal. It features two 3 way switches for the light up functionality. One switch controls the lights to flip between Blue and Orange. The other switch controls which power source the lights use, battery or when it's plugged into the wall so it can stay on without worrying about replacing the batteries. The switches are located at the handle and is easily toggled with your thumb while holding the prop. The "fingers" at the front of the gun are articulating to adjust to your preferred look. 

Prop Dimensions: 23.5" Long x 8.5" Wide x 8.5" Tall (measured without claw/tubes since those can vary/are soft)
Prop Weight: 4lb 12oz

A stand is now available to add to your order! It holds it via 2 rounded prongs (1 short/1 long) and can be displayed facing either direction. No glue required!

*** The prop does NOT make noise ***

NOTE ABOUT PLUG IN POWER: The plug in power does NOT charge the batteries. You will need to replace the batteries when they eventually run out of power. Plug in power is only for shelf display. Do not leave on for extended periods of time (24+hr) to help avoid damage to LEDs and extend the life of the prop.

All pieces are unpainted so there's no need to worry about scuffing it while at a Con or just sitting on your shelf!

SOME ASSEMBLY REQUIRED! Due to the fragile nature of some of the pieces on the prop there will be some assembly required to help prevent damage during shipping. The fingers screw onto the front through some small mounting pieces that stick out of the front cover and on top of the gun. The tubes are already glued to the rear cover with the tube mounting inserts already attached. These inserts go into 3 holes located at the same mounting points as the fingers. They stay in pretty well without glue but glue will be necessary for a permanent hold. After that, all you need to do is display your new favorite game replica! ;)

*** This is a 3D printed item so errors from the printing process (lines, blemishes etc.) & gluing errors (slightly misaligned pieces) may be present.

*** Items are handmade so minor variations from pictures may be present.

Follow me on Instagram for more! 
https://www.instagram.com/sterling3Dprints